TROUBLESHOOTING
In the event of a malfunction, first check all the cable connections and operating states:
1.Receiver and TV set power plugs are connected to wall socket
2.Antenna cables are connected to the receiver input
3.Receiver and TV set are correctly connected to each other by a HDMI or Scart or cinch cable
4.Audio connections are made to the
5.Receiver and TV set
6.Receiver is responding to remote control
A selection of troubleshooting tips is offered below.
Problem | Cause | Remedy |
| |
|
| Check the cable connection |
| |
A “No signal!” warning appears | Antenna signal is absent | between your receiver |
| |
and the cable socket. |
| |||
on some or all channels | or is defective. |
| ||
Refer to your cable network |
| |||
|
|
| ||
|
| operator or an antenna specialist. |
| |
|
| Set infrared code 1 as described |
| |
Remote control no | Receiver or remote control | in this manual under “Main |
| |
command set may have been | menu settings”, “Basic settings”, |
| ||
longer responding |
| |||
unintentionally changed | “Setting the remote control |
| ||
|
| |||
|
| code”, check the batteries |
| |
|
| On “Settings” - “Date and Time” |
| |
|
| setup menu check “Summer |
| |
| “Summer Time” setting wrong. | Time Enabled” and change as |
| |
| necessary Use the power switch |
| ||
Wrong time being displayed | An incorrect time was imported | change. | ||
to switch the receiver off from the | ||||
| from the reception signal | |||
|
| |||
| current channel, e.g. Das Erste |
| ||
|
|
| ||
|
| or ZDF, wait 10 seconds and | to | |
|
| then switch it back on | ||
|
| |||
|
|
|
Internet: http://www.kathrein.de
