Runco CW-42HD, CW-50XA Installation, Notes on Batteries, Notes on Remote Control, Operation

3. Installation

To install batteries in the remote control:

1.Remove the battery cover from the back of the remote control.

2.Insert the batteries included with the remote control. Ensure that the polarities correctly match the and markings inside the battery compartment.

3.Replace the battery cover.

If you have a CW-61 remote: After a few seconds, the remote starts up automatically and an Introduction screen appears. The remote control beeps twice to indicate that it has started up successfully.

3.1

Remote Control

• When installing batteries, make sure that the battery polarities are correct. Notes on Batteries

•Do not mix an old battery with a new one or different types of batteries.

•If you will not use the remote control for a long time, remove the batteries to avoid damage from battery leakage.

The remote control can be used to control the CinemaWall within the ranges shown in	Notes on Remote Control
Figure 3-1.	Operation

Approx.

7m/23ft

Figure 3-1.Available Range of the Remote Control

Runco CinemaWall Owner’s Operating Manual 13