FIRST INSTALLATION
Use the buttons to select whether the network search should be “On” or “Off”. If the network search is set to “On” you will be shown the “Manual Search” in the next display. You should use this if your cable network operator has advised you of the frequency that can be searched.
If you do not know the frequency or frequencies to be searched, set the network search to “Off”. You will
then be shown the “Automatic Search”. Press the buttons to access the line “Sorting”. Use the buttons to specify how the channels should be sorted in the channel list. You have the following options: “A to Z”, “Z to A”, by “Provider”, “Service ID” or “None”.
Press the buttons to access the next line. Press the button to go to the next menu:
Note: The frequencies, symbol rates and modulation settings used, and the channels available, may be different for different cable network operators. So as to keep the search time as short as possible, you can ask your cable network provider in advance for information on which channels are transmitted on which frequencies with which symbol rates and with which sort of modulation, and then set up the search accordingly.
Network search “Off”
If you do not know the frequencies used by your
cable network operator, use the button to select the lowest frequency permitted by the receiver for
starting the search (keep the button pressed untilfrequencythe line)button. is no longer shown in the start Press the buttons to access the next line.
Press the button to select the highest permitted by the receiver for ending the search (keep the
button pressed until the button is no longer shown in the end frequency line).
Network search “On”
If you know your cable network provider’s
frequency, use the buttons to set the desired start frequency for the search.
Press the buttons to access the next line. If necessary you can input the frequency again at this point, using the numeric pad buttons.
Press the buttons to access the next line. If necessary you can input the symbol rate again at this point, using the numeric pad buttons on the remote control.
Press the buttons to access the next line. If necessary you can set the type of modulation at
this point, using the buttons.
12
