CONNECTION AND SET-UP
The following section is intended specifically for specialist dealers. You need not refer to this section unless you are carrying out the installation yourself. The “Connection Example” section provides a sample configuration.
Do not connect the receiver to the mains until all installation work has been properly carried out. Refer also to the information in the “Safety Instructions” section.
CONNECTING THE RECEIVER
RF(HF) CONNECTION
Connect the RF input of the receiver to the antenna socket.
Use a coaxial cable with a standard IEC connector. If the IEC connector is not yet fitted to the cable, strip the insulation from the cable as shown in the following illustration and carefully fit the connector on to the end of the cable so that it is securely fitted.
|
|
|
|
Lengthwise slits (3×) | Bend back | Screw together | |
|
|
|
|
When fitting the connector, make sure that no wires from the braiding are touching the inner conductor, otherwise a short circuit will occur.
The quality of the reception signal depends on this connection!
TV CONNECTION
Connect the cable receiver (TV Scart socket) to the TV set using a Scart cable. If your TV has a stereo feature, you can receive the sound in stereo via the Scart connection. Connect the cable receiver to the video/DVD recorder using a Scart cable.
INSERTING BATTERIES INTO THE REMOTE CONTROL
Remove the cover on the rear of the remote control.
Insert the two batteries supplied into the remote control. Ensure correct polarity of the batteries; the + and
–markings are indicated inside the battery compartment. Slide the cover back into the housing until it locks into place.
7
