Programming TV programmes
The satellite receiver has already been factory
If your satellite receiving system uses a feed system with a different oscillator fre- quency, the receiver only needs to be matched to the feed system oscillator fre- quency during the installation.
The procedure for this can be found in section: “Initial settings, Oscillator fre- quency“.
Note on programme memory locations
The receiver has a 250 channel memory that can be assigned with TV or analogue radio programmes in any manner, and a 250 channel memory for ADR radio pro- grammes.
The analogue section of the receiver has been factory
150 TV programmes and
100 analogue radio programmes.
Programme memory is organised here so that the TV programmes are located in programme slots from 1 upwards, while the radio programmes are located in pro- grammes slots from 250 downwards. See also the following display:
Since only one sound programme (TV accompanying sound or a radio programme) can be stored in a programme memory, with the factory presetting:
in “TV mode“
on reception of TV programmes in programme slots 151 to 250 the original TV sound is not sent but instead the programmed radio sound
in “Radio mode“
on reception of radio programmes from programme slots 101 to 250 the sound of the corresponding TV programme is sent.
The assignment of the programme slots can be changed as desired.
Tuning in TV programmes
To tune in to new TV programmes, the video and audio reception parameters need to be set up accordingly.
The latest programme assignments can be obtained from satellite programme magazines, or called up via the videotext of programme Sat 1 from page 675.
∙Select the programme slot that you want to change.
∙Call up the video menu by pressing the keys 
+ 
in succession.
or
20
