Kathrein UFD 430 Receiver operation, Switching the unit on, Selecting a programme, ∙ Use the

Receiver operation

In this chapter, you learn how to select both TV and analogue and digital radio pro- grammes (ADR) using your receiver, how to adjust the volume and how to pro- gramme the timer functions.

In describing the functions, it is assumed that the receiver has already been prop- erly connected up by the specialist.

Should you want to undertake the connections yourself, please read the section: “Connecting up and putting into operation“ beforehand.

Switching the unit on

Switch the unit on via the mains switch on the unit. The last programme mode selected appears (TV, ADR or analogue radio) along with the last pro- gramme slot selected. If, before it was last turned off, the unit was switched into standby, it returns to standby mode the next time it is switched on via the mains switch.

In standby mode a horizontal line appears in the LED display “ – “.

	∙	The	key on the remote control switches the unit between normal operation
		and standby.
	∙
		You can also turn the unit on using the numeric keys		...	and the channel
		keys	.
Note	On switching on via the mains switch, the resulting operating state is always the
	same as it was prior to switch-off.

Selecting a programme

∙Use the numeric keys ... to select the desired programme directly. Example for a three-digit entry (free entry – see initial setting):

Selection of programme slot 147

∙1 is entered, programme slot 1 appears

∙4 is entered, programme slot 14 appears

∙7 is entered, programme slot 147 now appears.

	or
	∙ Use the	keys to step through the programmes in succession.
	After the programme changeover, the programme slot and programme name are
	superimposed on the screen for approximately three seconds.
Note	With the setting “2- or 3-digit programme selection“ there is a switch to the desired
	programme after approximately 3 seconds. Digits can be entered during this time
	period.

With the setting “free entry“ (in the above example) the receiver switches to the corresponding programme slot immediately after each input.

In the initial setup menu, a continuous on-screen display of the programme slot can be selected (see section: “Initial settings, On Screen Displays “).

Adjusting volume, balance and tone

∙Use the keys to adjust the volume to the desired level.

The volume is adjustable in 21 steps. The volume level set appears on the LED display for approximately 3 seconds. At the same time a bar indicator appears on the screen.

On Screen Display: LED display:

10