Model SB1017 | P R E P A R A T I O N | For Machines Mfg. Since 8/09 |
Power Connection
Electrocution or fire may occur if machine is ungrounded, incorrectly connected to power, or connected to an undersized circuit. Use a qualified electrician to ensure a safe power connection.
Once your machine is set up and assembled as previously described in this manual, it is ready to be connected to the power source.
•If you plan to use the machine at 110V, simply plug it into a receptacle on a 110V circuit that meets the requirements listed on Page 10.
•If you plan to use the machine at 220V, you will have to convert the machine for 220V. Refer to Electrical, beginning on Page 41.
Test Run
After all preparation steps have been completed, the machine and its safety features must be tested to ensure correct operation. If you discover a problem with the operation of the machine or its safety components, do not operate it further until you have resolved the problem.
Note: Refer to Troubleshooting on Page 38 for solutions to common problems that occur with
To test run your machine:
1.Read and follow the safety instructions at the beginning of the manual, take required safety precautions, and make sure the machine is set up and adjusted properly
2.Clear away all tools and objects used during assembly and preparation.
3.Open the downfeed valve and allow the saw to travel all the way down. If the blade contacts the machine base or the auto- OFF tab rests on the toggle switch, adjust the downfeed stop bolt as described in Downfeed Stop Bolt, on Page 35.
4.Connect the machine to the power source.
5.Put on safety glasses and secure loose clothing or long hair.
6.Lift the bandsaw by the handle. Close the downfeed valve to prevent it from lowering.
7.Start the bandsaw while keeping your finger near the ON/OFF toggle switch at all times during the test run. The bandsaw should run smoothly with little or no vibration.
—If you suspect any problems, immediately turn the bandsaw OFF, disconnect it from power, and correct the problem before continuing.
—If you need any help with your bandsaw call our Tech Support at (360)
8.Open the downfeed valve to lower the saw through its full range of motion. When it reaches the bottom of its travel, it should turn OFF. If it does not, manually turn it OFF, disconnect it from power, then proceed immediately to
Inspections &
Adjustments
The following list of adjustments were performed at the factory before your machine was shipped. If you find that the adjustments are not set according to the procedures in this manual or your personal preferences,
•Blade Tracking ..................................Page 35.
•Squaring the Blade ...........................Page 37.
•Blade Guide Bearings .......................Page 36.
