Model SB1017 | S A F E T Y | For Machines Mfg. Since 8/09 |
Additional Metal Bandsaw Safety
1.Blade Condition. A dull or damaged blade can break apart during operation, increasing the risk of operator injury. Do not operate with a dull, cracked or badly worn blade. Inspect the blade for cracks or missing teeth before each use.
2.Hand Placement. Hands could be cut by the blade or crushed when lowering the headstock. Never position fingers or thumbs in line with the cut or under the headstock while it is moving.
3.Blade Guard. Hands and fingers can easily be cut by the bandsaw blade. To reduce the risk of laceration injuries, do not operate this bandsaw without the blade guard in place.
4.Starting Position. To reduce the likelihood of blade breakage and possible entanglement, never turn the saw ON with the blade resting on the workpiece.
5.Blade Replacement. The blade can only make a safe and efficient cut if the teeth are facing the workpiece. When replacing blades, make sure the teeth face toward the workpiece. Wear gloves to protect hands and safety glasses to protect eyes.
6.Workpiece Handling. A shifting workpiece can result in impact or laceration injuries. To reduce the risk of injury, always securely clamp the workpiece in the vise and use additional support fixtures if needed. Never hold the workpiece with your hands during a cut. Flag long pieces to reduce the risk of tripping over them.
7.Power Interruption. Unplug the machine and turn the power switch OFF after a power interruption. If left plugged in and turned ON, this machine will start up when power is restored, resulting in possible entanglement, laceration, or amputation hazards.
8.Hot Surfaces/Sharp Edges. Due to the cutting process, a freshly cut workpiece, chips, and some machine components can be hot enough to burn you and sharp enough to cut you. Allow components to cool and use safe handling methods to reduce the risk of these injuries.
9.Moving Blade. A moving bandsaw blade presents a serious risk for laceration or amputation injuries. Always allow the blade to come to a complete stop before mounting or repositioning a workpiece in the vise. Never touch a moving blade.
