Southbend SB1017 owner manual Assembly, To assemble the bandsaw

For Machines Mfg. Since 8/09 P R E P A R A T I O N Model SB1017

Assembly

To assemble the bandsaw:

1.Attach the front and rear panels of the stand together as shown in Figure 7 with (6) M8- 1.25 x 15 hex bolts, (6) M8-1.25 hex nuts hex nuts, and (12) 8mm flat washers.

Rear Panel

x6 Front Panel

Figure 7. Front and rear panel assembly.

2.Place the assembly upside down on wood blocks to avoid scratching it or damaging the mounting tabs.

3.Attach the handle to the left side panel as shown in Figure 8 with two M8-1.25 x 15 hex bolts and 8mm flat washers.

Left Side Panel x2

Handle

Figure 8. Handle installation.

4.Attach the right side panel (the side without the handle) to the stand assembly as shown in Figure 9 with (7) M8-1.25 x 15 hex bolts,

(7) M8-1.25 hex nuts, and (14) 8mm flat washers.

		Right Side
Stand	x7	Panel
Assembly

Figure 9. Left side panel assembly.

5.Repeat the above step for the right side panel using (6) M8-1.25 x 15 hex bolts,

(6) M8-1.25 hex nuts, and (12) 8mm flat washers (see Figure 10 for assembled view).

Figure 10. Stand assembly.

-13-