Southbend SB1017 owner manual Loosen the belt tension bolt shown in Figure

Model SB1017 P R E P A R A T I O N For Machines Mfg. Since 8/09

6.Insert the axle through the holes in the base assembly, then slide the wheels over the axle and secure each with a cotter pin, as shown in Figure 11.

Axle

Base

Wheel

Cotter Pin

Figure 11. Wheel assembly.

7.Thread the leveling feet into the stand assembly, as shown in Figure 12. You can adjust these later as needed to level the bandsaw.

Leveling

Feet

Figure 12. Leveling feet.

8.With the help of another person, flip the stand assembly right-side up, then lift the bandsaw assembly and place it onto the stand assembly.

9.Secure the bandsaw to the stand with four M12-1.75 x 25 hex bolts and 12mm flat washers, as shown in Figure 13.

Hex Bolts

(2 of 4 Shown)

(Handwheel Not Yet

Installed)

Figure 13. Mounting bandsaw to stand.

10. Loosen the belt tension bolt shown in Figure

14.

(Pulley Cover Not	Belt Tension Bolt
Yet Installed)

Figure 14. Belt tension bolt location.

-14-