For Machines Mfg. Since 8/09 | O P E R A T I O N | Model SB1017 |
Vise
Always turn the saw OFF and allow the blade to come to a complete stop before using the vise! Failure to follow this caution may lead to injury.
The vise can hold material up to six inches wide and be set to cut angles from 0° to 45°.
Tools Needed | Qty |
Wrench or Socket 12mm | ....................................... 1 |
Machinist Square | 1 |
To use the vise:
1.Loosen the two hex bolts shown in Figure 37.
Hex Bolts
Figure 37. Vise hex bolts.
2.Use the scale as a guide to set your angle or use a machinist square to set the angle of the vise fence, as shown in Figure 38.
Scale
Figure 38. Squaring vise to blade.
3.Tighten the hex bolts.
4.Loosen the hex bolt on the vise jaw so the jaw can float, then match the angle of the workpiece and
5.Tighten the vise against the workpiece. Figure 39 shows the correct methods for holding different workpiece shapes.
NOT
RECOMMENDED RECOMMENDED
