Model SB1017 | M A I N T E N A N C E | For Machines Mfg. Since 8/09 |
| ! | Belt Tension Bolt |
|
| |
Hex Bolts |
|
|
Downfeed |
|
|
Ram Bracket |
|
|
Gear Box |
|
|
Cover |
|
|
Gear Box |
|
|
| Figure 50. Motor tension bolt. | |
Figure 49. Gear box location.
4.Remove the four hex bolts that secure the gearbox cover, then remove the gearbox cover and downfeed ram bracket.
5.Use a handheld oil pump to draw the oil out of the gearbox, then use a rag to remove any remaining oil and sediment.
6.Add oil to the gearbox until it is approximately half full, then replace the gearbox cover.
V-Belt Replacement
If the
3.Lift the motor to relieve the belt tension, then remove the belt.
4.Install a new belt, then release the motor and let its weight tension the belt.
5.
Machine Storage
All machinery will develop serious rust problems and corrosion damage if it is not properly prepared for storage. If decommissioning this machine, use the steps in this section to ensure that it remains in good condition.
To replace the V-belt
1.DISCONNECT BANDSAW FROM POWER!
2.Open the belt cover, then loosen the belt tension bolt shown in Figure 50 to allow the motor to pivot.
To prepare your machine for storage or decommission it from service:
1.DISCONNECT BANDSAW FROM POWER!
2.Thoroughly clean all unpainted, bare metal surfaces, then coat them with a light weight grease or rust preventative. Take care to ensure these surfaces are completely covered but that the grease or rust preventative is kept off of painted surfaces.
If the machine will be out of service for only a short period of time, use way oil or a good grade of
3.Loosen or remove the belt so it does not become stretched during storage.
