Initial settings
When making the setting, it should be ensured that there is at least one blank channel above and below the output channel in order to avoid interference.
OSD language
Here you can select the language for the
Default: German
LNB supply voltage
Here you can turn off the power supply for the feed system if this is catered for by an external power supply and signal selection likewise is not carried out through the LNB supply voltage (e.g. Kathrein
Note | If there are switchover matrices in the receiving system the LNB supply voltage |
| needs to be turned in all cases. |
| Default: ON |
LNB supply voltage in standby
When the receiver is in standby the LNB supply voltage is normally switched off. If terrestrial signals and satellite signals are combined in the receiving system, and the power supply for the relevant components comes from the receiver, this power supply must also be guaranteed when the receiver is in standby.
In this case switch the power supply in standby to “On“.
Default: “Off“.
Programme selection
You have the option of entering the programme number in
| Default: ”free“. |
|
|
| Setting |
| Settable programme slots |
|
| ||
|
|
|
|
|
| Programme slots 1 to 9 | |
|
| Programme slots 1 to 99 | |
|
| Programme slots 1 to 250 | |
| Free input |
| Programme slots 1 to 250 |
|
|
|
|
Note | If a recording is | ||
| must be cleared first in order that a change in the programme slot entry can be car- | ||
| ried out. |
|
|
On Screen Displays (OSD)
Here you can select whether the programme slot and programme name are to be displayed continuously, or whether they are to be removed again approximately three seconds after programme changeover.
This setting can be made differently in TV mode and radio mode.
Default: | TV mode | “Off“. |
| Analogue radio mode | “On“. |
To call the initial setup menu in analogue radio mode, the receiver must be switched into radio mode before being switched off. Then call the initial setup menu in the usual way.
28
