Kathrein UFD 430 manual Orbit position, Video deviation, Decoder menu

Programming TV programmes

Orbit position

In the “Orbit Position“ menu entry, division of the satellites into orbit positions 1 to 4 is carried out.

This dividing up is necessary for the signal selection with the 22 kHz, tone-burst or DiSEqC switching signal on reception from two (or more) satellites.

The receiver is pre-programmed in accordance with the following table.

Satellite	Orbit position	Switching signal 22 kHz
Astra 19.2° east	1	Off
Eutelsat 13° east	2	On
Eutelsat 10° east	3	Off
Eutelsat 16° east	4	On

In the pre-programming position 1 was again assigned to all other satellites.

Note	In the initial setup menu (DiSEqC menu, menu entry 22 kHz) the particular setting
	is specified (frequency band High/Low or orbit position Pos A/B) for which
	the 22 kHz switching signal is operative.
	Default setting in initial setup menu:
	22 kHz signal on for “Pos. A/B“.

Video deviation

The satellites transmit their signals with different video deviation, 16 or 25 MHz. The setting has an effect on the picture brightness.

∙ Adjust the video deviation to obtain optimum picture brightness.

Decoder menu

You can attach a decoder to the decoder Scart socket for a Pay-TV programme with video signal.

The receiver recognises Pay-TV programmes for which decoders deliver a switch- ing signal (e.g. like Premiere) independently, and switches this signal through to the TV- and VCR Scart socket:

For decoders that do not deliver a switching signal, the following setting is to be carried out

∙ Call up the video setup menu,

∙ Select menu entry “Decoder menu“, ∙ Activate the “Decoder menu“,

Setting option:

Internal / External

Internal / External

∙Set the video signal path to external,

∙Set the audio signal path to external only if audio signal is encoded as well.

∙Save the settings with the key (press twice).

22