Connecting up and putting into operation
Decoder connection
Decoders for reception of analogue
•Set up the connection to the secondary receiver as described above.
•Using a Scart cable, connect the decoder to the decoder Scart socket of the secondary receiver.
Take note of secondary receiver and decoder instructions.
Inserting batteries into remote control handset
Remove the cover on the rear of the remote control handset.
•Insert both of the batteries supplied into the remote control handset.
Make certain that the batteries are inserted with the correct polarity! Polarity is marked at the bottom of the battery compartment.
•Replace the cover again.
Exhausted batteries are special waste and should not be disposed of with household refuse. Instead, hand them in to a collection centre for used batteries!
Checking connections and operation
•Switch the satellite receiver on via the mains switch on the front of the unit. The LED display on the unit shows the programme slot P001.
•Switch on your TV set.
•Tune in to an
You can now receive the
If the “No Signal“ display is shown for all programme slots, the installation of the system should be checked out. However, if only certain programme slots are affected, this may be due to an interruption in the signal on the transmission side.
On-screen display OSD
Note: All figures refere to German programmes and the OSD in German language. How to select the OSD in English is explained on page 37.
10