Kathrein UFS 710sw, UFS 710si FIRST INSTALLATION Single-cable system Manual, Connected equipment

FIRST INSTALLATION: Single-cable system (Manual)

If one or more receivers are already present on the system and an additional receiver is to be connected, you must assign the new receiver a transmission frequency that is not already in use (otherwise the receivers will interfere with each other).

Depending on the system to which they are connected, a maximum of four or eight receivers may be connected to a single-cable system (a twin receiver counts as two receivers).

Connected equipment

Use the  buttons to select the type of system to which they are connected or the single-cable system components fitted (refer to the manuals, instructions and notes for the system and the system components). Available options:

-User-defined

-KATHREIN UAS 481 (single-cable feed system, max. four receivers)

-KATHREIN EXR 551 (single-cable switching matrix, max. four receivers)

-KATHREIN EXR 552 (single-cable switching matrix, max. two receivers)

-KATHREIN EXU 908 (single-cable matrix, max. eight receivers)

-	EXR 4 subscribers	(for future Kathrein single-cable switching matrices, max. four receivers)
-	EXR 8 subscribers	(for future Kathrein single-cable switching matrices, max. eight receivers)

Selection “user-defined”

Transmission channel

Use the  buttons to select a free available transmission channel.

Transmission frequency

Use the numeric pad to input the four-digit transmission frequency.

No frequency can be used by more than one receiver. The receivers would interfere with each other.

You can find the necessary information (transmission frequencies) in the documentation supplied with your system.

Secure channel with PIN

If your single-cable system allows the transmission frequency to be protected by inputting a PIN, this is the menu where that can be done. No other receiver can then use that transmission frequency unless the PIN is input.

Use the  buttons to select the setting “Yes”. A line with the text “Password PIN” is then displayed. Press the  buttons to select this line. You can now use the numeric pad to input a PIN (0-255).

23