FIRST INSTALLATION: Channel search

Execute Channel search

Use the  buttons to select (yes or no) whether you wish to start a channel search. It is not essential to start a channel search; instead you can use the factory pre-programmed channels. However the channels do change from time to time (e.g. their frequencies change), which the receiver does not automatically detect, and can then be found only by performing a channel search.

If you selected “No”, you can press the ! (green) button to skip directly to the next item of the first installation.

If you selected “Yes”, you can press the  button to progress to the next selection item.

Channel Search Mode

Use the  buttons to select whether you wish to search for “free & scrambled”, “free channels only” or “scrambled only” channels.

To view scrambled channels you need the appropriate CA (Conditional Access) module and a valid smart card together with a valid subscription to a pay TV provider.

Press the  button to move to the next selection item.

Network Search

If you set the network search to “Off”, only the factory stored transponders of the satellites you previously selected will be searched for new and as yet unlisted channels.

If you set the network search to “On”, the transponder network enables additional transponders that have not yet been stored to be located. They are then stored and searched for new channels in the same way as the existing transponders.

Press the ! (green) button to start the channel search, or if you set channel search to “Off” you are guided straight to the next item in the first installation process.

When the search has been completed, you will see the following message (example):

27

Page 27
Image 27
Kathrein UFS 902 manual Execute Channel search, Channel Search Mode, Network Search