![](/images/new-backgrounds/1163891/163891113x1.webp)
SEARCHING FOR CHANNELS (CHANNEL SEARCH)
Satellite
Select the satellite to be searched, using the buttons. Make sure your reception system is aligned to the selected satellite. You can search only one satellite at a time. If you have connected a
Press the button to move to the next selection item.
Channel Search Mode
Use the buttons to select whether you wish to search “free & scrambled”, “free channels only” or “scrambled only” channels.
To view scrambled channels you need the appropriate CA (Conditional Access) module and a valid smart card together with a valid subscription to the relevant pay TV provider.
Press the button to move to the next selection item.
Network Search
Use the buttons (On/Off) to select whether a network search should be performed. If you set the network search to “Off”, only the factory stored transponders of the satellites you previously selected will be searched for new as yet unlisted channels.
If you set the network search to “On”, the transponder network enables additional transponders that have not yet been stored to be located. They are then stored and searched for new channels in the same way as the existing transponders.
When you have made your settings, use the buttons to select “Start Search” and press
the button to start the search. You can cancel the search at any time by pressing the button. During the search you will see the following message (example):
Radio
channels found
TV channels found
Satellite with the
transponder
currently being
searched
Progression bar
57