Keating Of Chicago 0107 service manual Figures in determining proper size

PROBLEM	PROBABLE CAUSE	SOLUTION
Flames come out	a.Burners misaligned.	a.Adjust position of burners.
front.	b.Exhaust problems.	b.Install deflector to block down draft.
		Install or adjust flue restrictors. If problem
		persists, contact your HVAC
	c. Radiants have slipped forward.	representative.
		c. Reposition radiants.
	d.Flue blockage.	d.Turn Custom Pasta System and manual
		gas valve off. Let flue cool and remove
		foreign objects.
Custom Pasta	a.Baskets overfilled.	a.Don’t overfill baskets.
System has poor	b.Water won’t stop filling or overfills.	b.Check water auto-fill system.
recovery.	c. Scale on heat transfer tubes.	c. Boil-out Custom Pasta System
	d.Radiant problem – collapsed or out of	d.Reposition or replace radiants.
	position.	e.Replace thermostat.
	e.Faulty or erratic thermostat.
	f. Low supply or gas pressure.	f. Verify if size of incoming gas line to
		Custom Pasta System and manifold gas
	g.Exhaust problems.	pressure are adequate.
		g.Contact your HVAC representative.
Burners won’t come	a.Water level is too low (below lower	a.Check water auto-fill system. Fill Custom
on although runner	sensor).	Pasta System to proper level.
despite proper water	b.Low water safety shut-off operated.	b.Check low-water safety shut-off system.
level.
Custom Pasta	a.Product overloaded in Custom Pasta	a.Follow recommended cooking production
System vessel boiling	System vessel.	figures in determining proper size of
over or excessive	b.Excessive amounts of starch causing	loads.
starch overflow.		b.Replace water, then clean sensors and
	foam.	vessel.
Basket-Lift	a.Connections are loose or timer is faulty.	a.Tighten connections. Replace timer if
mechanism won’t	b.Motor limit switch is faulty.	faulty.	Replace
operate.		b.Replace limit switch (14" model).
	c. Lift motor is faulty (14" model).	actuator (18" and above models).
		c. Replace motor. Specify left or right side
	d.Actuator is faulty (18" and above	motor when ordering.
		d.Replace actuator.
	models).	e.Replace fuse (use type SC-5 in 14"
	e.Control circuit fuse has blown or circuit
	breaker in rear or under control panel	model and type SC-3 in 18" and above
	has tripped.	models) or reset circuit breaker.
	f. Relay is faulty (18" and above models).	f. Replace relay.
Basket-Lift motor	a.Cam is slipping on motor shaft	a.Tighten cam screw onto flat on motor
runs, but basket	(14" model).	shaft.
doesn’t move.	a.Basket-Lift motor limit switch is
Basket-Lift basket		a.Align limit switch.
goes down, but won’t	misaligned (14" model).
go up.
Basket-Lift buzzer	a.Buzzer limit switch is misaligned	a.Align limit switch.
won’t shut off.	(14" model).
	13