Keating Of Chicago 2006 warranty Digital Timer Part # Programming, Operating Logic, Pause Feature

STEP 2 PRESS all 3 buttons in sequence: left-center- right. The BEEPER will BEEP. If BEEPER does not BEEP, the timer is defective. STOP TESTING. Reset procedure is completed when 1:00 appears on the digital display.

1:00

DIGITAL TIMER (PART # 030834)

PROGRAMMING

To program the timers, the unit must be in the idle mode. Press and hold the set but- ton for approximately two seconds. The display will show “SEt”. Press the button for the channel to be programmed. The

display will show the current setting for that channel. Use the up or down button to increment or decrement the setting. When the setting is correct, press and hold the set button again for approximately two seconds. The display will show "StO" for approximately two sec- onds and the timer will return to normal operation. Repeat the process as necessary for the other timers.

OPERATING LOGIC

When the timer is powered up, the display will show the time setting for the channel that was operated last and the relay output contacts will be open. To start a cycle, press the desired channel button (1-3). The display will begin to countdown from the preset time setting and the relay output contacts will close. During the countdown the colon will flash at a one-second rate. When the countdown has reached "00:00" the relay output contacts will open, the display will flash, and the audible alarm will sound. To cancel the audible alarm, press any button.

PAUSE FEATURE

To pause a cycle in progress, press any button. The relay output contacts will open, the display will flash, and the countdown will pause. To resume the countdown, press any button. The display will resume the normal countdown and the relay output contacts will close.

CANCELING A CYCLE

To cancel a cycle in progress press and hold any button for approximately two seconds. The relay output contacts will open and the display will show the time setting for the channel last used.

DRAINING

ALWAYS SHUT THE FRYER OFF COMPLETELY BEFORE DRAINING. THE FRYER SHOULD BE DRAINED ONLY UNDER THE SUPERVISION OF PROPERLY TRAINED PERSONNEL. A DRAIN PIPE AND COVERED CONTAINER SUITABLE FOR USE WITH HOT OIL SHOULD BE USED TO ENSURE THE SAFETY OF THE OPERATOR.

1.Operator should be outfitted with proper attire including:

–Oil and heat resistant gloves –Oil and heat resistant apron –Safety goggles

–Oil and heat resistant footwear

Figure 3-2

Side view of Safe & Easy Filter

2.Turn off the fryer and open the door.

3.Put suitable container under drain valve (for Safe & Easy models, slide filter onto rails inside of fryer or filter cabinet).

4.• Front Drain: Drain oil from fryer by slowly turning handle. The drain will be completely open after 1/4 turn.

• Rear Drain: Pull black knob forward slowly.

5.After fryer drains, close the drain valve.

6.Filtering may be done at this step - refer to filter manual.

CLEANING AND BOIL-OUT

When cleaning and boiling out your fryer use Keating Sea Powder and Keating Klenzer to keep your fryer in top condition. Keating Sea Powder dissolves any grease build up — even carbonized grease in fryer vessels — one of the leading causes of premature oil breakdown. Once your fryer vessel is clean, use Keating Klenzer, the finest dry stainless steel polish available, to restore your Keating Incredible Frying Machine®’s (IFM) exterior to its original luster.

7