Datalogic Scanning QS6500BT manual Intercharacter Delay, No Delay

Interface Features

Keyboard Wedge/USB Keyboard — cont.

Intercharacter Delay

This feature does not apply to the USB Keyboard interface.

NOTE

START
MODE		BARCODE
	This delay is inserted after each data character trans-
	mitted. If the transmission speed is too high, the sys-
	tem may not be able to receive all characters. You may
	need to adjust the delay to make the system work prop-
	erly. Selectable from 00 to 255 in 10msec increments.
	Use hexidecimal (range: 00 to FF hexidecimal) to set
	the delay.
	To configure this feature, scan the “START” bar code
	above to place the unit in Programming Mode, then the
	“Set Intercharacter Delay,” followed by the digits from
	the Alphanumeric table in Appendix B, Alpha-
	Numeric Pad representing your desired length.
	Accept your selection by scanning the “SET” bar code
	below and finally, exit programming mode by scanning
	the “END” barcode below
	DEFAULT SETTING FOR THIS FEATURE:
		00 (No Delay)
Set
Intercharacter
Delay
SET
END

Product Reference Guide 4-33