Datalogic Scanning QS6500BT manual Code below

Data Editing

Preamble/Postamble — continued

START
MODE		BARCODE
	Sets up to 22 characters each from the set of ASCII
	characters or any hex value from 0 to FF. To config-
	ure this feature, scan the “START” bar code above to
	place the unit in Programming Mode, then the “SET
	PREAMBLE” or “SET POSTAMBLE,” followed by the
	digits from the Alphanumeric table in Appendix B,
	Alpha-Numeric Pad representing your desired
	character(s). Reference the section, Example: Set-
	ting a Postamble, for more information. Accept your
	selection by scanning the “SET” bar code below,
	scan the “TRANSMIT PREAMBLE” (or “TRANSMIT
	POSTAMBLE” as applicable) bar code, then finally,
	exit programming mode by scanning the “END” bar-
	code below.
	DEFAULT SETTING FOR THIS FEATURE: 00 (None)
Set Preamble
Disable
Preamble
Transmit
Preamble
Set Postamble
Disable
Postamble

5-6 QuickScan® QS6500/QS6500 BT