QuickScan QS6500/QS6500 BT | Datalogic Scanning QS6500BT specs

Symbologies

The leading or ending digits of bar code data characters can be trun- cated. Select from 00 (no truncation) to 15.

The imager will beep instead of reading anything when

the truncate value is more than the bar code data digits

or the truncate leading value overlaps the truncate end-

NOTE

START

MODE

BARCODE

Sets from 00 to 15 characters to truncate from either the leading or ending charac-

ters of scanned bar code data. To configure this feature, scan the “START” bar

code above to place the unit in Programming Mode, then the SET TRUNCATION:

LEADING or SET TRUNCATION: ENDING, followed by the digits from the Alpha-

numeric table in Appendix B, Alpha-Numeric Pad representing the desired

quantity of digits to trumcate from the message string. Accept your selection by

scanning the “SET” bar code below and finally, exit programming mode by scan-

ning the “END” barcode below.

Set Truncation:

Leading

Set Truncation:

Ending

SET

END

Datalogic Scanning QS6500BT manual QuickScan QS6500/QS6500 BT