Datalogic Scanning QS6500BT manual Fixed Length Control

Symbologies

Interleaved 2 of 5 — continued

Fixed Length Control

One or two fixed lengths may be configured for Interleaved 2 of 5. Lengths must be even and must include any check digit that may be in the bar code. If Length 1 or Length 2 are set to non-zero values, the min- imum and maximum length settings are ignored. To disable fixed lengths, set Length 1 and Length 2 to a value of 00.

To configure this feature:

1.Determine the length settings needed for Fixed Length 1 and Fixed Length 2, then reference Appendix A, ASCII Conversion Chart to find the corresponding hex values for your chosen lengths. Select- able lengths are from 0x00 to 0x64 (from 0 to 100 decimal).

2.Scan the START bar code below.

3.Scan either the Set Fixed Length 1 or Set Fixed Length 2 bar code.

4.Turn to Appendix B, Alpha-Numeric Pad and scan the hex digits rep- resenting the desired length. For example, scan 00 to disable the feature, or 0A to set the length to 10.

5.Scan the SET bar code to accept the digits scanned.

6.Scan the END bar code to exit Programming Mode.

6-92 QuickScan® QS6500/QS6500 BT