Thedirtsensorlightsystemismountedon
Itconsistsofa seriesof threeredlightsand onegreenlight
| Thelightsgive | |
| youan indica- | |
| tionof the | |
| amountof dirt | |
| particlesthat | |
| arepassing | |
Dirt Sensor | thru the sensor | |
(Some Models) | on | its way to |
| the | dust bag. |
INITIAL START UP
When the
lowing light sequences occurs in a two sec- ond time frame:
1, All three reds come one
2.Two reds are one
3.One red is on.
4.One green is on and will remain on until the
dirt on it, dirt will be picked up by the vacuum and one or more red Iights might stay on.
IN OPERATION
When the
When the green tight stays on as the Power- Mate® is moved back and forth over an area, the sensor is not seeing enough dirt to war- rant further cleaning of that area,
NOTE: Dirt sensor tights DO NOT function in the FLOOR setting.
CLEANING LENS
Although the dirt sensor feature in your Kenmore
1. Remove the | °U | |
| ||
wands by press- |
| |
ing the quick |
| |
release | pedal and |
|
lifting up | on the |
|
wands |
|
|
2, As indicated by the illustration, the two dirt sensor elements are located on the inside of
the swivel, approximately 31/2inches/90 mm down, (note the arrows). Each element should be cleaned periodically. To reach the sensor elements, use a small brush such as a bottle brush. Brush each sensor element several times to remove dust and dirL
NOTE: Looking down inside the swivel you will see a ring° The sensor elements are located just slightly below this ring°
3.Reinstall the wands after cleaning the sen- sors.
CAUTION
The residue of the water or cleaners will accelerate the recoating of the lenses and make cleaning necessary
sooner.
t | t | ,i | i, , _ _ t |
10