Kenmore 116.22813, 116.22812 owner manual To Replace Belt, latches, then pull

TO REPLACE BELT

1. Slide washers

and end caps onto agitator assembly,

2.Install new belt over motor

drive, then over brush

sprocket,

NOTE: See	Motor
PARTS AND	Brush Drive
FEATURES for	Sprocket
Belt Number	End Cap Agitator

3. Place agitator

assembly back into Power-Mate®o

4.Reinstall

agitator cover by Iin-

ing up the front tabs

and	slots
and	rotating
downward
until	the	Agttafor Cover

latches

snap into placeo

5. Line up			_L_
front	of		\
cover	and
base.	Rest
front	edge	of	_.
cover	on
base	as
shown.			Cover	Base

[ Top View

6, NOTE: On dirt sensor models be sure that the

board is upright and the wires are tucked back as shown.

7.Rotate cover

back. Press cover

firmly until side and rear tabs snap

into place. Turn Power-Mate ®

upside down and replace two (2) cover screws,

Push In

3. Push in and turn

1.Remove Power-Mate ® cover as shown in BELT CHANGING AND AGIfATOR CLEAN- ING section,

Push In	2.	Push in and		turn
And Turn	bulb		counterclock-
	wise,		then pull	out
	to	remove,

And Turnbulb clockwise, to replace, Bulb must not be higher than 15 Watts(130 Volts).

4.Reinstall Power-Mate e cover as shown in

BELT CHANGING AND AGITATOR CLEAN- ING section,

NOTE: See PARTS AND FEATURES for Bulb Number

18