Kenmore 116.31732 cleaning the unit, Failure, to d lt, in electrical shock or personal injury

Review this chart to find do-it-yourselfsolutions for minor performance problems. Any service needed, other than those described in this owner'smanual, should be performed by an autbo- dzed service representative.

_or		cleaning the unit, Failure
I	to d_lt	in electrical shock or personal injury.

Cleaner won't run,

Poor job of dirt pick-up.

fl,

Cleaner picks Up moveable rugs or

!pushes too hard. Light won'twork. Agitator does not turn.

!1. Unplugged at wall outlet.

2.Tripped circuit breaker/blown fuse at household service panel,

3.On/off switch not turned on.

4.Thermal protector tripped,

1.Full or clogged dust bin.

2.Wrong pile height setting.

3.Worn agitator.

4.Clogged nozzle or dust bin porL

s.Clogged hose. g, Hole in hose.

7.Broken/misplaced belt.

8.Hose not Insorled fully

9.Motor proteclion syslem activaled.

10, Dirty riflers

I1. Sliders not rotating.

1.Wrong p+r= height selling

1.Burned out light bulb.

1.Broken belt.

2.Bare floor selector in bare floor setting.

3.Belt installed incorrectly.

1.Plug in firmly, push onibff switch Io on g. Reset circuit breaker or replace fuse

3.Push on/off swilcb to on,

4.Reset thermaf protector, (page 11)

1.C_ean dust bin, (page 14).

2.Adjust setting, (page 7),

3.Replace agitator, (page 22)

4.Check CLOG REMOVAL, (page 20).

5.Check for cFogs, (page 20).

6.Replace hose,

7.Replace/fix bell, (page 17-19)

8, I_sort hess fLilly, (pngo 10}.

9.Check for clogs, (page 20),

10.Clean/change filters, (page 15-16).

11.Remove obslructions, (page !5)

1, Adjosl selling, (pngo 7)

1.Change light bulb, (page 21).

1.	Replace bell, (pages 17-19).
2.	Move selector to the carpet se_ng,
	(page 7).
3.	Check BELT CHANGJNG AND
	AGITATOR CLEANING, (pages 17-19)

Performance		indfcator,		1.	Full or cl0gged dust bin.
some models, Is red.				2.	Dirty filters.
				3.	Clogged airflow passage.
				4.	Certain attachment tools.
Air flow restricted				1.	Attachment	use restricts air flow
with attachment			use.	2. New carpet fuzz clogged air path.
Sound changes.
Excessive	rloJse as			1.	Belt rubbing	on carpet/bare floor
vacuum	is shut		off.		selector shaft,
Dirt Sensor,		some		1.	Dirty optic cells.
models,	will not		work.

1.	Clean	dust bin,(page		t4).
2.	Clean/change		filters, (page		15-16).
3.	Ciear	clog from air/low		passage,
	(page	20)
4.	This is normal		Light should		go off
	when	tool is removed.

t_', Check ATFACHMENTS, (page 8)

2, Check CLOG REMOVAL and cFean

hose, (page 20)

1.Push seleclor af_ the way forward, (page 7).

1.Clean optic celts, (page 12).