NOTE: See PARTS AND FEATURES for belt #.
Loop the other end of the belt on the belt pulley on the agitator.
insert the agitator by placing the rounded portion of the end cap down into the slot in the nozzle base.
NOTE: It may be necessary to hold the fur- niture guard out of the way in order to allow proper insertion of the agitator into the noz- zle base.
Agilato
Nozzle | End | Base | |
Base | |||
Cap | Slot | ||
|
NOTE: Care must be taken due to the belt tension during reassembly.
Press firmly,
checking to see that
each end is
completely inserted.
Check to see that the belt is centered on
the belt pulley.Turn the agitator with your
fingers to see that it turns freely.
To | Locking | |
cover, | insert |
|
the six | (6) |
|
tabs into the |
| |
the agitator | @_ | |
six slots |
| |
along | the |
|
front edge of | Tabs/ | |
the nozzle | Slots |
base.
Lower the agitator cover to its original posi- tion. After positioning the agitator cover, push forward on the two (2) locking tabs in order to ensure that they are securely in place.
Furnltur_ | |
lurniture | Guard |
guard retain- |
|
ers to the |
|
posts on both |
|
sides of the |
|
agitator | Agitator |
cover. | Cover |
NOTE: If the agitator cover is not installed correctly, you may experience a loss of per-
formance and possible agitator vibration, etc.
Headlight;ire
Lock Tabs
__SecurelyIn
Make sure the headlight wires are tucked securely in place.
Replace the nozzle cover and secure
the latches.
Nozzle
_n