Toselectapileheightsetting:
Turn off cleaner. Select a pile height setting by tilting the cleaner back until front wheels are lifted slightly off the floor as illustrated.
Slide the adjustment lever to the correct setting.
SUGGESTED PILE HEIGHT SE'N'INGS
You may need to raise the height to make some jobs easier, such as scatter rugs and longer pile carpets. Suggested settings are:
HIGH: shag carpet, long pile, plush, scatter rugs.
MED: medium to long pile.
LOW: short to medium pile.
EX LOW: very low pile.
SOME MODELS
Bare floor setting: Slide the carpet]bare
floor selector all the way back and down toward the bottom of the nozzle until it locks
into place.
In this position the brush assembly does not revolve. This setting should be used for cleaning hardwood and tile floors and when any attachments (tools) are used.
Carpet setting: Slide the selector all the way forward and up to the carpet position.
In this position the brush assembly wilLturn. When carpets are being cleaned the selec- tor should be in this position.
Attention: Refer to your carpet manufac- turers cleaning recommendations. Some more delicate carpets may require that they be vacuumed with the agitator turned off, to prevent carpet damage.
iiiiiiii¸
I 'WARNING
Personal Injury Hazard
DO NOT place hands or feet under-
neath the unit when changing from the bare floor to the carpet pile height setting,The agitator begins to revolve rapidly when the vacuum is turned on and is in the carpet set- ting,
!CAUTION
Do not allow vacuum cleaner to remain in one spot for any length of time when the agitator Is turning. Damage to carpet may occur,
Note: For longer belt life, turn vacuum off before moving selector, otherwise make sure
the selector is pushed fully and quickly as
possible to the desired position. Failure to do so can cause the belt to rub on the
selector shaft and may result in the belt
becoming hot and creating a burning rubber smell.
Carpet/Bat_
Floor Selector
To Carpet
Position
To Bare Floor
Position
\