|
|
|
| FOR YOUR SAFETY | READ BEFORE | UGHTING |
|
|
|
| |||||||||||||||
|
|
|
| WARNING: | If you | do | not | follow these | instructions | exactly, | a | fire | or |
|
|
| |||||||||
|
|
|
| explosion may result causing property damage, personal injury or loss of life. |
|
| |||||||||||||||||||
BEFORE OPERATING: | ENTIRE SYSTEM MUST BE FILLED W}TH WATER AND AIR PURGED FROM ALL LINES. | ||||||||||||||||||||||||
A. This | appliance | has | a pilot | which is lit by a piezo | electric |
| If | you | cannot reach | your | gas supplier, | call | the fire | ||||||||||||
gas | ignition system. | Do not open | the inner | door | of the |
| department. |
|
|
|
|
|
|
|
|
|
|
| |||||||
appliance and try to light the pilot by hand. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||||||
B. BEFORE UGHTING smell all around the applianoe area | C. | Use only your hand to | push | in or turn the | gas | control | |||||||||||||||||||
| knob. Never | use | tools. | If the | knob will not push in or turn | ||||||||||||||||||||
for gas. Be sure to smell next to the floor because some |
| ||||||||||||||||||||||||
| by hand, don't try to repair it, call a qualified service | ||||||||||||||||||||||||
gas is heavier than air and will settle on the floor. |
|
| |||||||||||||||||||||||
|
| technician. | Force | or attempted | repair | may | result | in a fire | |||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
| ||||||||||||||
WHAT TO DO IFYOU SMELL GAS: |
|
|
|
|
| or explosion. |
|
|
|
|
|
|
|
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||||||
Do not try to light any appliance. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||
Do not touch any electric switch; do not use any phone | D. | Do not | use | this | appliance | if any part | has | been under | |||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||||||||||
in your building. |
|
|
|
|
|
|
|
|
| water. | Immediately | contact | a qualified | installer or service | |||||||||||
Immediately | call | your | gas supplier from a | neighbor's |
| agency | to replace |
| a flooded | water heater. Do not attempt | |||||||||||||||
phone. Follow | the | gas | supplier's instructions. |
|
|
|
| to repair the unit! |
| It must | be replaced! |
|
|
| |||||||||||
|
|
|
|
|
|
| UGHTING | iNSTRUCTiONS |
|
|
|
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
| FmGURE "A" |
| HGURE "g" |
|
| HGURE "C" |
|
|
|
|
|
| MAI_ 8U_NER |
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| / |
|
|
|
|
|
|
|
| "OFF | POSITION | "PILOT" | POSITION |
|
| "ON" | POSITRON |
|
|
|
|
|
|
|
|
|
| ||
1,
2.
3.
4,
5.
7,
8.
TOPKNOB
GAS CONTROL
STOPI Read the safety information above on this label.
Set the thermostat to lowest setting (PILOT LIGHTING).
Turn thermostat dial fully clockwise t_ until it stops. Push the gas control knob down slightly and turn clockwise
f_ to"OFF", SEE FIGURE 'W'.
NOTE: Knob CANNOT be turned from "PILOT" to "OFF" unless it is pushed down slightly. Do not force.
Remove the outer burner door located below the gas control.
Wait five (5) minutes to clear out any gas. If you then
smell gas, @ STOPI Follow"B" in the safety information above on this label. If you don't smell gas, go to next step. This unit is equipped with a push button pilot igniter, which is used to light the pilot. Locate the igniter on the gas control.
Turn gas control knob counterclockwise _'_ to "PILOT", SEE FIGURE "B".
The pilot is located on the right side of the burner. It can be located by looking through the glass view port while pressing the piezo igniter button several times. Look for a spark at the pilot location, FIGURE "D'.
FIGURr: "D"
9.Once the pilot has been found, push the gas knob all the way down. Immediately press the pilot igniter button rapidly
(4)to (5) times. If the pilot will not light, repeat step (3) through (9).
10.Continue to hold the gas control knob down for about one
(!)minute after the pilot is lit. Release the gas control knob and it will pop back up. Pilot should remain lit. If it goes out, repeat step (3) through (9). It may take several minutes for air to clear the lines before the pilot will light.
°If knob does not pop up when released, stop and immediately call your service technician or gas supplier.
°If the pilot will not stay lit after several tries, turn the gas control knob clockwise f_ to "OFF" and call your service technician or gas supplier. SEE FIGURE "A".
11.Once the pilot flame is established replace the outer burner door.
12.At arms length away, turn gas control knob counterclockwise ('_ to "ON". SEE FIGURE "C".
13.Set thermostat to desired setting.
DANGER: Hotter water increases the risk of
scald injury. Consuk the instruction manual
before changing temperature.
_to | "OFF". Do not force. SEE FIGURE "A". |
18
