PICKING UP BOBBIN THREAD
o Raise presser foot lever.
Hold needle thread loosely in left hand
and push needle up/down switch two times or rotate hand wheel toward you one complete turn.
/
®
®
. Bring bobbin thread up by pulling upper thread.
,Pull both threads under and to the back
of the presser foot, leaving 3 to 4 inches of thread clear.
If you can not pick up bottom thread by following above steps, then check:
1.Is needle threaded ?
2.Is thread tangled around needle ?
3.Is bobbin case threaded correctly with thread going through slots A and B as shown on page 9, Fig. 4 and 5 ?
4.Is there 4 inches of thread coming from bobbin case and through slot of needle plate as shown on page 9, Fig. 6 ?
5.Is thread from bobbin case tangled ?
11
