Kenmore 17920, 17922 manual Changing Needle, Changing Presser Feet

Flat side

away from

you

Fig. 1

! j

Foot ho 1

Fig. 2

Foot thumb screw

CHANGING NEEDLE

Raise needle bar to its highest position by turning the hand wheel toward you. Loosen the needle clamp screw. Holding the needle with the flat side away from you, slip the needle into the needle bar. When it is in as far as it will go, tighten the needle clamp screw

with small screwdriver provided in the accessory box.

PRESSER FEET

This machine is supplied fitted with a zigzag presser foot for general sewing purposes.

In the accessory box are the following additional presser feet:

1.Straight stitch foot

2.Metal and plastic satin stitch feet

3.Buttonhole foot

4.Built-in buttonhole guide foot

5.Zipper foot

6.Blind hem foot

7.Overcasting foot

8."Q FOOT",+

9.Even feed foot

10.Narrow hemmer

11.Edge stitcher

CHANGING PRESSER FEET

Be sure needle is in the up position. Raise presser foot lever.

Snap-on presser feet

1.Raise foot release lever to remove the foot. (Fig. 1)

2.Place the desired foot on the needle plate aligning needle holes. (Fig. 1)

3.Lower the presser foot lever so that the foot holder snaps on the foot. (Fig. 2)

One-piece presser feet

1.Loosen presser foot thumb screw and remove the foot holder.

,Insert desired foot from the front. Lower the presser foot lever and tighten the screw using the large screw driver to make certain the foot is secure.

17