Kenmore 17922, 17920 manual Even Feed Foot, Adjustable Holder

EVEN FEED FOOT

The even feed foot moves top and bottom material together evenly and enables you to sew hard-to-sew fabrics without sliding nor slipping and with perfect matching. Use it for sewing leather, ultra suede TM, shiny fabrics (vinyls, patents and satin-',), bonded fabrics, pile fabrics and matching stripes, plaids and patterns. It is not recommended for use when stretch stitching.

To attach the even feed foot;

1.Raise needle to its highest position.

2.Raise presser bar to its highest position and guide the even feed foot into position from rear of machine,,

3.Attach presser bar clamp to presser bar and tighten presser foot thumb screw.

4.Attach screw (A) provided with the foot to needle clamp through fork arm and tighten it.

Note: Attach the foot in exact order of steps as written.

IMPORTANT:

To prevent friction and wear, put a drop of oil at each point indicated by arrows in Fig. 2 and set pressure regulator at 2 or 3 before using this foot.

Oil after 4 or 5 times usage. Be sure to remove

excess oil by wiping foot thoroughly and sewing on a scrap of fabric.

ADJUSTABLE HOLDER

Replace the regular presser foot holder with the adjustable holder when using narrow hemmer and edge stitcher attachment.

Loosen thumb screw and press it forward.

Insert the opposite end into the large hole of the attachment. Slide the attachment to the

left as far as possible. Adjust as necessary to the correct position for stitching. Tighten the thumb screw securely.

Presser bar

Needle clamp

arm

Presser foot
thumb screw
Presser	Screw (A)
clamp

Fig. 1

Fig. 2

I

Narrow

hemmer

screw

18