NEEDLE PLATES
You are provided with two needle plates:
A. Needle plate with wide oval hole for all zigzag stitches and striaght stitch with needle at "C" (center) or "R" (right) position.
B. Needle plate with round hole for straight stitch with needle at "'S" (standard) position.
CHANGING NEEDLE PLATE
1.Raise needle to its highest position and raise presser foot.
2.Remove bobbin cover plate.
3.Remove needle plate by placing thumb under edge of plate and lifting up and out. (See Fig. 2)
4.Make sure bobbin case is in the proper
position by turning in the counter- clockwise direction as indicated by red
arrow on the bobbin case stopper until it stops. (Fig. 3)
5.Snap desired needle plate into place.
(Fig. 4)
6.Replace bobbin cover plate.
NOTE:
Don't turn hand wheel while needle plate is removed, or needle may hit bobbin case and cause needle damage.
Don't touch screws on the bobbin case stopper.
If bobbin case is not installed as indicated above, it will be damaged when the needle plate is put into position.
FEED COVER PLATE
There are a few times when you want to control the feeding of the fabric yourself.
Raise needle to its highest position and raise presser foot. Place feed cover plate over needle plate aligning two pins of feed cover plate with holes of needle plate. You may then determine the movement of the fabric yourself.
AB
Fig. 1
Fig. 2
Fig. 3
Bobbin Case Stopper
Bobbin case Bobbin case Fig. 4 stopper
20
