WINDING THE BOBBIN
®®
. Place thread on Telescoping Spool Pin. Draw thread through Rear Thread Guide and Bobbin Winder Tension Disc as indicated.
. Pull end of thread through any hole in bobbin; place bobbin on Bobbin Winder
Shaft with end of thread coming from top of bobbin as shown above.
Pull out to disengage
Push in to engage
®
3.Push Bobbin Winder Latch against bobbin until it clicks. Then pull Hand Wheel away from machine to disengage clutch (see
diagram below). Hold end of thread coming from bobbin (see above) and step on foot control. After several rotations of bobbin release thread.
4.When bobbin is full, winding stops
automatically. Push in Hand Wheel. Remove bobbin from shaft and trim thread end.
_< Treat Hand Wheel as a "clutch"
It controls the needle mechanism so that when pulled out (disengaged), the rest of the machine will not operate while the bobbin is being wound.
For best stitching results use clear plastic lightweight bobbins when stitching at high speed with widest and longest stitch setting.
8