Button Sewing
1 | Stitch selector: | 3 |
2 | Stitch width: | 2 to 5 |
3 | Stitch length: | Any |
4 | Needle thread tension: | 2 to 6 |
5 | Presser foot A: | Button sewing foot |
6 | Feed dogs: | Dropped |
1.Insert the rear pin on the foot into the groove of the foot holder. Gently lower the presser foot lifter while holding the foot with your finger.
2.Place a button on the fabric and lower the needle by turning the handwheel with your hand, so that the needle enters through the left hole in the button.
3.Align the direction of button and lowrer the button sewing foot to hold the button in the place.
Adjust the stitch width so that the zigzag width matches the span of holes in the button.
4.Press foot control and sew about 10 stitches.
5.Cut the needle thread at the beginning.
6.Pull the bobbin thread to pull the needle thread to the wrong side of the fabric.
7.Tie both threads together.
Overcasting
1 | Stitch selector: | 3 |
2 | Stitch width: | 5 |
3 | Stitch length: | Red zone |
4 | Needle thread tension: | 3 to 8 |
5 | Presser foot A: | Zigzag foot |
6 | Presser foot C: | Overedge foot |
7Brush holder seam guide
This stitch is useful in garment construction, and in finishing raw edges of any sewing project.
If using the zigzag foot, start overcasting with the leftmost needle position about 1/8˝ (0.3 cm) from the raw edge of a seam. The right tip of the stitch should just clear the seam edge.
For lightweight fabrics, use the overedge foot. To sew, line the fabric edge up with the inner side of the brush holder seam guide 7 .
1
4
5
4
3
1
4
5
4
3
2
3
56
2
3
5 | 6 | 7 |
or o ou
54
