Kenmore 580.75116 Installation Requirements, If you use an existing well sleeve, you should

Remove packing materials from the wall sleeve and tape from the air conditioner.

INSTALLATION REQUIREMENTS

If you use an existing well sleeve, you should

measure its dimensions.

Install the new air conditioner according to these installation instructions to achieve the best performance. All wall sleeves used to mount the new air conditioner must be in good structural condition and have a rear grille to securely attach the new air conditioner. (FIG. 1)

With the Kenmore sleeve, you can maintain the best performance of the new air conditioner. (FIG. 2)

(511 ram)

18+W_(468 mm)
Air Conditioner	FIG. 1
_6	ram)

	.{42S ram)
Kenmore Wall Sleeve	FIG, 2

ELECTRICAL SERVICE

Check your available electrical service. The power supply available must be the same as that shown on the unit nameplate (found on left side of cabinet).

INSTALLATION HARDWARE

ITEM	NAME OF PARTS			Q'TY	/
	PLASTIC	GRILLE		1
	VERTICAL	INSULATION	STRIP	1
(_7	AROUND	INSULATION	STRIPS	2
(_	HORIZONTAL INSULATION STRIP			1
(_)	SUPPORT	BLOCK		2
@	BAFFLE			1
	TRIM FRAME			2
@	SHIM			2
(_	PLASTIC NUTS AND WASHER SCREWS			4
_0	GRILLE REAR			1

To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may be exposed:

•Air conditioners covered in this manual pose an

excessive weight hazard. Two or more people are needed to move and install the unit.

To prevent injury or strain, use proper lifting and carrying techniques when moving unit.

•Carefully inspect location where air conditioner

will be installed. Be sure it will support the weight of the unit over an extended period of time.

•Handle air conditioner with care. Wear

protective gloves whenever lifting or carrying the

unit. AVOID the sharp metal fins of front and rear coils.

•Make sure air conditioner does not fall during installation.

All models are equipped with a 3-prong service plug to provide proper service and safe positive grounding. Do not change plug in any way. Do not use an adapter plug. If your present wall outlet does not match your plug, call a qualified electrician to make the necessary corrections. SAVE CARTON for storage and this OWNER'S MANUAL for future reference. The carton is the best way to store unit during winter or when not in use.

REQUIRED TOOLS:

•Tight Fitting gloves

•Standard screwdriver

•Phillips screwdriver

•Pliers

•Sharp knife

•3/8-inch open end wrench or adjustable wrench

•1/4-inch hex socket and ratchet

•Tape measure

•Electric drill

•1/4-inch drill bit

-5-