PROCEDURE A
1If you are using the new sleeve (optionally supplied with your unit),skip to step 3.
Otherwise, install the plastic grille from the kit. Cat the plastic grille to
FIG. 4
I_ll Fasten the 4 washer screws to secure the grille to the wall sleeve. If you need plastic nuts to mount plastic grille to the inside of the wall sleeve, there are plastic nuts in the installation kit. The nuts are installed from the inside of the sleeve and are pressing into the square holes of the rear flanges.
J
or
FIG. 5
Plastic rear grilte
Steelrear
FIG. 7
II_ Install the new unit into the wall sleeve.
rltTo | assemble trim, snap | the tab of each piece | / | ||
| into the slot of the other | piece | as | shown below. | |
| Slide trim over the front of the | air | conditioner | ||
| until trim is flush with sleeve as shown below. | ||||
Trim (2 ea)
Wall
Ell Remove the backing from the Vertical Insulation strip 159/16x 13/8x 13/8and attach that
to the inside right of the sleeve as shown below. Remove the backing from the Around
Insulation strip 67% x 13/8x 25/32and attach that to the inside front of the sleeve as shown
below.
Indoor Outdoor/
" 9V2" =i_ 6" _i
FIG. 6
I_ll Remove the metal rear grille and replace it with the plastic rear grille to improve unit energy
efficiency. The plastic grille reduces the amount of
hot air discharge that recirculates through the unit.
FIG. 8
•Airconditionerscoveredinthismanualposean excessiveweighthazard.Twoormorepeopleare neededto moveandinstallthe unit. Topreventinjuryor strain,useproperliftingand carryingtechniqueswhenmovingunit.
•Whenhandlingtheair conditioner,becarefulto avoid cutsfromsharpmetalfins onfrontandrearcoils.
•Makesureairconditionerdoesnotfall during removal.
•If unitdoes notoperateafterinstallationcheck,to be surethe circuitinterrupterhasnot beentripped.Refer tothe Troubleshootingguidefor resetprocedure.
