CONTROL PANEL
-FAN SPEED
Every time you push this button, it advances the setting as follows: {High , Low _Med * High}
| Applied | to 580.75085 | |
|
| 580.75116 | |
| RECEIVER | ||
| • Use this button to automatically control the | ||
| temperature of the room. | ||
| The temperature can be set within a range | ||
| of 60°F to 86°F by increments of I°F. | ||
| • The setting appears in the display. | ||
| • To turn the air conditioner ON, push this | ||
| button. |
| |
- | To turn the air conditioner OFF, push the | ||
• You will usually use | button | again. | |
• This button takes priority over any other | |||
• If unit is running, use Timer to set number of | |||
button. |
| ||
hours until |
| ||
• When you first turn it on, the unit is in | |||
• For your sleeping comfort, once Time is set, the | |||
cool mode, High fan speed, Temperature | |||
Temperature setting will raise 2°F after 30 min., | |||
setting | at 72°F. | ||
|
and once again after another 30 min.
•Push Timer button to advance setting from 1Hour
*2Hours * ... > 12Hours maximum.
-START TIME
•If unit is off, use Timer to set number of hours before unit starts.
•Push Timer button to advance setting from 1Hour >2Hours >... * 12Hours maximum.
MODE
-Push this button to shift mode of operation from COOL >ENERGY SAVER >FAN.
-COOL:
•Fan runs continually for normal cooling operation
-ENERGY SAVER:
•The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will check the room air temperature to determine if cooling is needed.
-FAN:
•
_ed | after an electrical power failure, the unit will begin to run at its last setting. | ] |