Kenmore 624, 614 To Clean Agitator, To Replace Belt, Agitator Assembly, front of, base. Rest

TO CLEAN AGITATOR:

NOTE: In order to keep cleaning efficiency high and to prevent damage to your vacu- um, the aaitator must be cleaned every time

The agitator must also be cleaned accord- ing to the following schedule:

Vacuum Use Clean Aoitator

TO REPLACE BELT

1.Install new belt over

motor drive, then over

brushMotor

sprocket.Drive

HEAVY - every week

NOTE: See

PARTS AND

Sprocket

(used daily)
MODERATE -	every month
(used 2-3 times/week)
LIGHT -	every 2 months
(used 1 time/week)

IMPORTANT

Disconnect cleaner from electrical outlet. Check and remove hair, string and lint build- up frequently in the Power-Mate ® agitator and end cap areas,

Remove any dirt or debris in the belt path area or in the brush roller area.

Carefully remove any string or debris located on the agitator, or end caps.

Agitator Assembly

Belt Pulley_

Brush Unit

Agitator End Cap

FEATURES

for belt number.

2assembly. Place agitator/back into Power- Matee.

3. Line up

front of

cover and

base. Rest

cover on

front edge of base as

shown.

CoverBase

4.Rotate cover

back.	Press
cover	firmly until
side and rear
tabs snap into
place.
Make sure there		Rear
is no gap		Latches
		Latch

between the cover and base.

5.Turn Power-Mate®upside down and replace two (2) cover screws.

17