Kenmore 624, 614 Canister, Hood And Tool Storage Cover, Hose, To Remove, ment, buttonand

CANISTER

1.Open the canister hood.

2.Check to see that the dust bag is proper-

ly installed. See BAG CHANGING for instructions.

3.Check to see that the motor safety filter is properly installed. See MOTOR SAFETY FILTER CLEANING for instructions.

HOOD AND TOOL

STORAGE COVER

it is normal for the canister hood and tool

storage cover to come off when opened fur- ther than needed. Line up the hinge slots, insert the hinges into the slots, and close the hood and tool storage cover to reinstall.

CAUTION

Never open canister hood with the tool storage cover open. This will help to prevent damage from occurring to the canister hood and/or tool storage cover,

This canister is equipped with an on-board

storage area for a Power-Mate Jr. = attach-

ment.

To Install:

Open the Power-Mate Jr.® storage cover. Insert the Power-MateJr.", press down into place, and close the lid securely.

To Remove:

Open the storage cover. Remove Power- Mate Jr.® from the storage area and use as needed (see AI-IACHMENTS and ATTACH- MENT USE).

HOSE

1. Line up the hose
latch tab and notch
in canister hood
and insert hose
into canister until it
snaps in place.
To remove: Lift
hose latch tab	Notch
upward and pull up
on hose.				Pl
	2. Insert
			han-	H
Handl	die into wand			I
	until lock		but-
	ton snaps		in
	place. Be
	sure	hose is
Lock	not twisted.
	To remove:
--	Press	handle
Handle	quick	release
Quick	buttonand
Release_	pull up on
I	handle.

To store: Disconnect hose from wands and canister to prevent stress on hose during storage. Store hose in a loosely coiled

position so the hose covering is not stressed.

Power-Mate Jr. _

Storage Cover