Kenmore 624, 614 Edge Cleaner, Overload Protector, Suction Control, Cleaning Area, Attachment

					CLEANING AREA
ATTACHMENT				Between			Bare	Carpeted
			Furn_ure*Cushions*			Stair=	Floors
					Drapes°			Floors/Rugs Walls
CombtnaUon	.Dusting	!	X		x			X
	oruan
brash	Fabric	_	X		x
	brush
Crevice tool			X	X
Floor brush	€;_					x	x	X
Power'Mate=							X**	X
Hand!-:.',.;:_Jr."			x			x
(SomeUodet=)'*'
Power-Mate Jr.•			x			x
(SomeMod,s)--	_	_;_

*Always clean attachments beforeusingon fabrics. "* 3-way OnJOflswitchshouldbe in FLOOR position,

*** Handi-MateJr.2 and Power-MateJr."attachmentinstructionsare includedwiththe products.

NOTE: When separating wands, depress lock button complete y before pullinqwands apart. If wand lock button is difficult to depress, push the two wands more tightly together to line up the lock button with the hole. Depress lock button and then pull wands apart.

EDGE CLEANER

Active brush edge

cleaners are on both sides of the Power- Mate`=. Guide either side of the Power-

Mate" along base- boards or next to

furniture to help remove dirt trapped at carpet edges.

OVERLOAD PROTECTOR

SUCTION CONTROL

The suction

control allows

you to change the vacuum

suction for

different fabrics SuctionSuction

and carpet

weights. Opening the control decreases suction for draperies and lightweight rugs, while closing the control increases suction for upholsteries and carpets.

The Power-Mate ° has

built-in protection against motor and belt damage should the agitator jam. If the agitator slows down or stops, the overload protector shuts off the Power-Mate ®. The

Overload Protector

Personal Injury Hazard

Always unplug the vacuum cleaner before cleaning the agitator area as brush may suddenly restart. Failure to do so can result in personal

canister motor will continue to run.

To correct problem: Turn off vacuum, remove obstruction, then press reset button.

To reset: Press the overload protector button. A ball point pen may be required.

injury.

11