EXTRA RECHARGE
Sometimes, a manually initiated recharge (regeneration) may be desired, or needed. Two examples are:
•You have used more water than usual (guests visiting) and you may run out of soft water before the next automatic regeneration.
•You did not add salt to the softener before it ran out. Add salt to the softener before regenerating.
You can start a regeneration immediately, or you can set the controller to regenerate at the next preset recharge time (2:00 AM, or as set).
RECHARGE NOW
Press the REGENERATION button and hold for 3 sec- until the words "RECHARGE", "Serv" and "Fill"
begin to flash in the display. The softener enters the fill
cycle of regeneration immediately. This regeneration will take about 2 hours to complete. Then, you will have soft water again.
NOTE: If the "Clean Feature" is set ON, the normal regeneration cycle is preceded by a cleaning backwash and rinse. The words "CLEAN" and "Bkwsh" or "Rinse" flash in the display, along with the minutes of the clean cycle remaining.
RECHARGE
WATERFLOWFigure 21
RECHARGE TONIGHT
Press and release (do not hold) the REGENERATION button. "RECHARGE TONIGHT" will begin flashing in the display, and the softener will begin regeneration at the next preset recharge time (2:00 AM, or as set). If you decide to cancel the regeneration before it starts, press and release the RECHARGE button once more. "RECHARGE TONIGHT" will stop flashing in the dis- play.
5J.r_
RECHARGETONIGHT
ii::i WATERFLOW Figure 22
SALT MONITOR SYSTEM
The water softener has a salt monitor indicator light to
remind you to add salt to the storage tank.
NOTE: You must set salt level each time salt is added
to the water softener.
NOTE: The salt monitor system estimates salt levels, and accuracy will vary with different salts.
To set this monitor system:
1.Lift the salt lid and level the salt in the storage tank.
2.The yellow salt level decal, on the brinewell inside the tank, has numbers from 0 to 8 (see Fig. 23). Observe the highest number the leveled salt is at, or closest to.
Salt Level
_,ess f_tcn'cjht Low
Level | Decal | _ | _"_) | _'i" |
k_L_ |
| hold | for immediate |
|
Figure 23
3.Press the SET SALT LEVEL button as many times as necessary to make the salt level bars in the display (see Fig. 23) match the number on the decal. At level 2 or below, the "Low Salt" indicator will flash.
4.If you want to turn the salt monitor off, press the SET SALT LEVEL button past 8, until "OFF" shows in the display next to the number 8.
PM
i OFFI | J: | IE |
WATERFLOWFigure 24
Questions? Call the Kenmore Water Line
15
