Model No. 625.383500
Model Code | 350 |
12,600 @ 2.5 Ibs.
Rated Softening Capacity (Grains @ Salt Dose)26,900 @ Z9 Ibs. 32,100 @ 13.3 Ibs.
Rated | Efficiency | (Grains/Pound |
| of | Salt | @ Minimum Salt Dose) | 5,090 | @ 2.5 Ibs. | ||||||||
Rated | Service | Flow | Rate |
|
|
|
|
| 8.0 | gpm | ||||||
Amount |
| of | High | Capacity | Ion | Exchange | Resin | 0.83 | cu. ft. | |||||||
Pressure | Drop | at | Rated | Service |
| Flow |
|
| 10 psig |
| ||||||
Water | Supply | Max. | Hardness |
|
|
|
|
| 90 | gpg |
| |||||
Water | Supply | Max. | Clear | Water | Iron |
| 11 ppm* |
| ||||||||
Water | Pressure | Limits | (minimum | / maximum) | 20 | - 125 | psi | |||||||||
Water | Temperature | Limits | (minimum | / | maximum) | 40 | - | 120 | °F | |||||||
Minimum | Water | Supply Flow | Rate |
|
|
| 3 gpm |
| ||||||||
Intermittent | Flow | @ | 15 psi |
|
|
|
|
| 10 gpm** |
| ||||||
Maximum |
| Drain | Flow | Rate |
|
|
|
|
| 2.0 | gpm | |||||
*Capacity to reduce clear water iron is substantiated by WQA test data. State of Wisconsin requires additional treatment if water supply contains clear water iron exceeding 5 ppm.
**Intermittent flow rate does not represent the maximum service flow rate used for detemi-
ning the softener's rated capacity and efficiency. Continuous operation at flow rates greater than the service flow rate may affect capacity and efficiency performance.
These systems conform to NSF/ANSI 44 for the specific performance claims as verified and substantiated by test data.
The efficiency rating is only valid at the stated salt dose. These softeners were efficiency rated according to NSF/ANSI Standard 44.
Variable Salt Dose: The salt dose is selected by the electronic controls at regeneration time based on the amount needed.
IN - OUT
|
| I |
FRONT VIEW | SIDE VIEW | Figure 1 |
Questions? Call the Kenmore Water Line
4
