Kenmore 625.3835 manual View

Warranty		.....................................................................................				2
Safety	Guides			..................................................................................		3
Specifications				& Dimensions		4
Packing		List	...................................................................................			5
Plan Your Installation					..........................................................................	5-7
Installation						7-11
Programming			the Softener			12-13
Sanitizing		the		Water	Softener	14
Adding		Salt to		the	Storage Tank	14
Controller		Features			...........................................................................	15-18
Care	of	Your	Water		Softener	19
Service		Information			..........................................................................	19-22
Exploded		View		& Parts List		24-27

•Read all steps and guides carefully before installing and using your new water softener. Follow all steps exactly to correctly install. Failure to follow them could cause personal injury or property damage. Reading this manual will also help you to get all the benefits from your water softener.

•Your Kenmore water softener will remove hardness minerals from water. This is measured in grains per gallon (gpg). It will also remove some clear water iron _:. This is measured in parts per million (ppm). See the specifications page for the maximum limits of hardness and iron removal.

•A water softener will not improve other water prob-

lems such as acidity, tastes and odors, or iron other than clear water iron.

•Do not attempt to use this product to make safe drinking water from non-potable water sources. Do

not use the system on microbiologically unsafe water, or water of unknown quality without adequate disin- fection before or after the system.

•Check with your local public works department for plumbing and sanitation codes. You must follow their guides as you install the system. Follow your local codes if they differ with guides in this manual. In Massachusetts, plumbing code 248-CMR 3.00 and 10.00 shall be adhered to. Consult with a licensed

plumber.

•Use only lead-free solder and flux for all sweat-solder connections, as required by federal codes, when installing soldered copper plumbing.

•Use care when handling the water softener. Do not turn upside down or drop.

•Avoid installing in direct sunlight. Excessive heat may cause distortion or other damage to non-metallic parts.

•This water softener works on water pressures of 20 psi

(minimum) to 125 psi (maximum). If your house water pressure is over the maximum, install a pressure reduc- ing valve in the water supply pipe to the softener.

•This softener works on 24 volt, 60 Hz electrical power only, supplied by a direct plug-in transformer (includ- ed). Be sure to use the included transformer and plug it into a nominal 120V, 60 cycle household outlet that is properly protected by an overcurrent device such as a circuit breaker or fuse. If transformer is replaced, use only the authorized service, Class II, 24V 10VA transformer.

•Do not install the water softener outside, or in extreme

hot or cold temperatures. Temperature of the water supply to the water softener must be between 40°F and 120°F. Do not install on hot water.

_: The capacity to reduce clear water iron is substantiated by Water Quality Association test data.

European Directive 2002/96/EC requires all electrical and electronic equipment to be disposed of according to Waste Electrical and Electronic

Equipment (WEEE) requirements. This directive or similar laws are in place nationally and can vary from region to region. Please refer to your state and local laws for proper disposal of this equipment.

Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com

3