Kenmore 625.38376 owner manual Installcovers, Restart the Water Heater, Program the Timer, Ic ,Iiu

INSTALLCOVERS

After installing your water softener, replace the covers. Angle the covers so the main cover clips onto the back first, then bring down in front and clip on the two (2) tabs inside the rim of the salt hole and lower the salt cover closed. See Fig. 23.

RESTART THE WATER HEATER

Turn on the gas (or electric) supply to the water heater and light the pilot.

YOUR PLUMBING INSTALLATION AND ELECTRICAL WORK ARE NOW COMPLETE.

Salt Level Adjust Display

Signal Light

Adjust

Tank Light

PROGRAM THE TIMER

1.When the transformer is plugged in, the model code H 32, and a test number (example: J1.1) show in the face plate display for 4 seconds. Then, 12:00 AM and PRESENT TIME begin to flash.

NOTE: If ';- - -"shows in the display, press the UP or

DOWN button until either H 32, for model 38376, or H 33, for model 39376, shows in the display. Then, press the SELECT button to set, and change to the flashing PRESENT TIME display.

2.To check the model code, unplug the transformer at the wall outlet and plug in again. If other than this code shows, refer to the Troubleshooting Section. SOUND "BEEPER": A "beeper" sounds while pressing buttons for timer setup. One beep signals a change in the face plate display. Repeated beeps mean the timer will not accept a change from the button you have pressed, telling you to use another button. For example, while setting the hardness the beeper sounds repeatedly when the display reaches 1 using the DOWN button, or the highest hard- ness setting using the UP button.

	Salt Hole
Cover	Cover
(Main)

FIG. 23

REGENERATION Button

UP Button

DOWN Button

SELECT Buttons

FIG. 24

	17	_-IC		- -8- -		IC,I_IU
						PRESENT	TIME
_ i_	I	I	I
	I I	-I	-I
_____	J	J,J		_ __	_
	17	_7-I				i 7,1717 AM
				- -8-	-	IC ,I_IU
						PRESENT	TIME
_ i_	I I I 7I -II
_____	J	J,J		_ ___	_

FIG. 25

Questions? Call The Kenmore Water Line 1-800-426-9345

17