Kenmore 625.38376 owner manual Salt Bridge

SALT BRIDGE

Sometimes, a hard crust or salt bridge forms in the salt storage tank. It is usually caused by high humidity or the wrong kind of salt. When the salt bridges, an empty space forms between the water and salt. Then salt will not dissolve (melt) in the water to make brine. Without

brine, the resin bed does not regenerate and you will have hard water.

If the storage tank is full of salt, it is hard to tell if you have a salt bridge. Salt is loose on top, but the bridge is under it. The following is the best way to check for a salt bridge.

Salt should be loose all the way to the bottom of the tank. Hold a broom handle, or like tool, up to the softener as shown in Fig. 54. Make a pencil mark on the handle, 1" or 2" below the top height of the rim. Then, carefully push it straight down into the salt. If a hard object is felt before the pencil mark gets to the top of the tank, it'smost likely a salt bridge. Carefully push into the bridge in a few places to break it. Do not try to break the salt bridge

by pounding on the outside of the salt tank. You may damage the tank.

If the wrong kind of salt made the bridge, take it out. Then fill the tank with nugget or pellet salt only.

SALT BRIDGE

Push tool into

salt bridge to break

1 _'- 2"

i

Pencil Mark

Broom Handle

Salt

Salt Bridge

space

Water Level

FIG. 54

Questions? Call The Kenmore Water Line 1-800-426-9345

29