![](/images/new-backgrounds/1093416/9341619x1.webp)
Before Setting Surface Controls
Cooktop Display Windows
The cooktop controls provide a digital display for each of the cooking zone located on the cooktop. Power levels and messages are easily monitored and adjusted using the corresponding control keypads in combination with the window displays.
The Available Power Level Settings
The cooktop control will display heat levels ranging from
Hi (Figure 1) to Lo (Figure 6), OFF (Figure 7) and Pb (Power Boost; Figure 8). The settings between 9.5 (Figure 2) and
3.0(Figure 3) decrease or increase in increments of .5 (1/2).
The settings between 2.8 (Figure 4) and 1.2 (Figure 5) are Simmer settings which decrease or increase in increments of .2 (1/5) to Lo (Figure 6; lowest Simmer setting) for more precise settings at lower heat levels. The highest setting
"Power Boost" (Figure 8) provides approximately 139% power for 10 minutes.
Fig. 1 | Fig. 2 | Fig. 3 | Fig. 4 |
Fig. 5 | Fig. 6 | Fig. 7 | Fig. 8 |
Sabbath Feature (Sb) Message
The cooktop display windows wiii show the Sb message whenever the Sabbath feature is active (Figure 11). When activated, the Sabbath feature works for both the oven and cooktop together. Once the Sabbath feature is active, changes to the heat levels for the cooktop heating elements will not show in the displays. The cooktop wiii react slower to heat level changes. See Sabbath feature section for complete instructions.
Fig. 11
Cooktop Lockout (--)
Use the Cooktop Lockout to lock all surface elements from being accidentally turned ON (including Warmer Zone). This feature will only lockout the cooktop features.
To turn the Cooktop Lockout feature ON:
1.Be sure aii surface element controls are OFF.
2.Press and hold Cooktop Lockout keypad until acceptance tone sounds (about 3 seconds).
When the cooktop is locked, the cooktop locked indicator icon will appear in the oven control display window (Fig. 12).
Hot Element Indicator Message (HE)
After using any of the cooking zones on the cooktop, the glass surface may be HOT from resldual heat transferred from the cookware and burns may occur if surface is touched.
The control monitors the temperature of the cooktop and displays the message "HE" (hot element) warning when the cooktop is still too hot to touch (Figure 9). If the HE message appears in the window, the control can still be turned on again for use.
Fig. 9
Power Failure (PF) Message
The PF message (Figure 10) will be displayed whenever there has been a power interruption to the appliance. The PF message will disappear by itself after a few seconds.
Fig. 10
Fig. 12
The
Fig. 13
If a triple beep sounds (entry error tone) instead, check and be sure all surface elements are turned OFF before
activating the Cooktop Lockout feature.
To turn the Cooktop Lockout feature OFF:
Press and hold Cooktop Lockout keypad until acceptance tone sounds (about 3 seconds). The cooktop locked indicator light will turn OFF and the cooktop may be used for normal cooking operations.
Important notes:
°If Cooktop Lockout is active and a power failure occurs, when power is restored the cooktop wiii remember the setting and remain locked.
°Starting a Flex Clean cycle will automatically turn ON the Cooktop Lockout feature. The cooktop wiii remain locked until the Flex Clean cycle is finished and the oven door has unlocked.
10