Self=CleaningiNSTRUCTiONS PRESS DISPLAY
Stopping or interrupting aSelf-Cleaning Cycle
If it becomes necessary to stop or interrupt a self-cleaning cycle
due to excessive smoke or fire in the oven:
1. Press 0.
2. Once the oven has cooled down for approximately 1 HOUR
and the "DOOR LOCKED" icon is no longer displayed, the
oven door can then be opened (Figure 1).
Note: Self-Clean cycle can never be set to start more than 12 hours in advance.
Figure 1
Adjusting Oven Temperature
The temperature in the oven has been pre-set at the factory. When first using the
oven, be sure to follow recipe times and temperatures. If you think the oven is cooking
too hot or too cool for the temperature you select, you can adjust the actual oven
temperature to be more or less than what is displayed. Before adjusting, test a recipe
by using a temperature setting that is higher or lower than the recommended
temperature. The baking results should help you to decide how much of an adjustment
is needed.
Note: The oven
temperature adjustments
made with this feature will
not change the Self-Clean
cycle temperature or the
Broil temperature.
INSTRUCTIONS
To adjust the oven temperature higher
1 Press _a'ke'_i_for 6 seconds (Figure 2).
• \ ,
2. To increase the temperature use the number pads to enter the
desired change (Example 30°F) _ (_ (Figure 3). The
temperature may be increased as much as 35°F (19°C).
3. Press to accept the temperature change and the display
will return to the time of day (Figure 4). Press G to reject the
change if necessary.
To adjust the oven temperature lower
/y,,v,_,, 0°
1. Press _B_ke)for 6 seconds• will appear in the display (Figure 5).
2. To decrease the temperature use the number pads to enter the

desiredchange/Example-30°F)@ @ andthenpress@

(Figure 6). The temperature may be decreased as much as 35°F
(lg°C).
3. Press to accept the temperature change and the display
will return to the time of day (Figure 7). Press O to reject the
change if necessary.
Note: The oven temperature adjustments are permanent and will
stay forever in the unit memory unless you manually change it again.
Even a power outage will not reset these changes. Follow the same
procedure again if you wish to change it to a different setting.
PRESS
Qdb
or
QQ
Q

orC)

DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
_iiil................
........iii.......
39