Setting Warmer Drawer Controls

Arranging Warmer Drawer Racks

Operating the Warmer Drawer

Arranging Warmer Drawer (Warm & Ready TM Drawer) Rack Positions (some models)

Note: Use the warmer drawer to keep hot foods hot such as: vegetables, gravies, meats, casseroles, biscuits and rolls, pastries and heated dinner plates.

The rack can be used in 2 ways:

In the upright position to allow low profile food items to be placed both under and on top of the rack (for example, rolls or biscuits on top of the rack and a casserole dish under - See Fig. 1).

In the downward position to allow you to place light weight food items and empty dishware (for example, rolls or pastries and dinner plates - See Fig. 2).

The warmer drawer is equipped with a catch which may require extra force when opening and closing the drawer.

To Operate the Warmer (Warm &

Ready TM) Drawer

Always start with hot food. It is not recommended to heat cold food in the warmer drawer.

All food placed in the warmer drawer should be covered with a lid or aluminum foil to maintain

quality. Do not use plastic wrap to cover food.

Plastic may melt onto the drawer and be very difficult to clean.

Use only dishes, utensils and cookware recommended for oven use in the warmer drawer.

Always use pot holders or oven mitts when removing food from the warmer drawer as cookware and plates will be HOT.

Warmer Drawer Recommended

Food Settings Table

Food item

 

Setting

Bacon

 

Hi

Hamburger Patties

Hi

Poultry

 

Hi

Pork Chops

 

HI

Fried Foods

 

HI

Pizza

 

HI

Gravies

 

MED

Casseroles

 

MED

Eggs

 

MED

Roasts (Beef,

Pork, Lamb)

MED

Vegetables

 

MED

Biscuits

 

MED

Rolls, hard

 

MED

Pastries

 

MED

Rolls (soft)

 

LO

Empty Dinner

Plates

LO

Fig. 3

To Set the Warmer (Warm & Ready TM) Drawer Thermostat Control (some models)

The thermostat control is used to select the temperature of the warmer drawer. It is located on the control panel (See Fig. 3). To set the thermostat, push in and turn the knob to the desired setting. The temperatures are approximate, and are designated by HI, MED and LO.

1.Turn the knob to select the desired temperature setting.

2.For best results, preheat the drawer before adding food. An empty drawer will preheat in approximately 15 minutes.

3.Turn the thermostat control to OFF after use.

Warmer (Warm & Ready TM) Drawer Temperature Selection (some models)

Refer to the table in the side column for recommended settings. If a particular

food is not listed, start with the medium setting. If more crispness is desired, remove the lid or aluminum foil.

Most foods can be kept at serving temperatures by using the medium setting.

When a combination of foods are to be kept warm (for instance, a meat with 2 vegetables and rolls), use the high setting.

Refrain from opening the warmer drawer while in use to eliminate loss of heat from the drawer.

29

Page 29
Image 29
Kenmore 790.9446 manual Setting Warmer Drawer Controls, To Operate the Warmer Warm Ready TM Drawer